wsm L503 Workshop Manual page 109

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Cabin Assembly
1. Remove the outer roof of cabin.
2. Support the cabin with nylon straps (1) and hoists.
3. Loosen and remove the cabin mounting bolts (2) and nuts (9).
4. Dismounting the cabin from tractor body.
NOTE
• Lift the cabin while making sure it does not catch on
anything.
(When reassembling)
• Be sure to install the washers and mount rubbers, etc. in their
original positions.
• Before mounting the cabin, be sure to set both the shuttle lever
rod and the shuttle arm to the neutral position, and then connect
the shuttle lever rod securely. (manual and GST model)
Cabin mounting bolt and
Tightening torque
nut
(1) Nylon Straps
(2) Bolt
(3) Plate
(4) Mount Rubber
(5) Collar
(6) Plain Washer (M14)
Hydraulic Pipes
1. Remove the main delivery pipe 1 (2).
2. Remove the PTO delivery pipe (3). (Manual and GST model)
3. Disconnect the suction hose (1) from hydraulic pump.
4. Remove the joint bolt (4) of oil cooler pipe (5). (HST model)
(When reassembling)
Joint bolt for main delivery
pipe 1 to front hydraulic
block
Joint bolt for PTO delivery
Tightening torque
pipe
Joint bolt for oil cooler pipe
(1) Suction Hose
(2) Main Delivery Pipe 1
(3) PTO Delivery Pipe
(4) Joint Bolt
1-S22
ENGINE
124 to 147 N·m
12.6 to 15.0 kgf·m
91.1 to 108 ft-lbs
(7) Washer
(8) Spring Washer
(9) Nut
F : Front Side
R : Rear Side
W1067482
49 to 69 N·m
5.0 to 7.0 kgf·m
36.1 to 50.6 ft-lbs
34 to 39 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 ft-lbs
34 to 39 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 ft-lbs
(5) Oil Cooler Pipe
[A] GST Model
[B] HST Model
W1067766
KiSC issued 02, 2007 A