wsm L503 Workshop Manual page 291

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Transmission Bearing Holder
1. Remove the transmission bearing holder mounting screws.
2. Jack up the bearing holder (7) by using the two jack screws until
the taper roller bearing (9) can be removed.
NOTE
• Jack up the bearing holder while hitting the two shafts (2) (5)
by copper hummer or soft hummer.
3. Jack up more and remove the transmission bearing holder (7).
(When reassembling)
• Tap in the transmission bearing holder with soft hummer until
contact to transmission case, and then tighten the screws to
specified torque.
Transmission bearing
Tightening torque
holder mounting screw
(1) Creep Gear Shaft (Creep Gear Type)
(2) Spiral Bevel Pinion Shaft
(3) Range Gear Shaft
(4) Shift Fork Rod for Range Gear Shift
(5) PTO Drive Shaft
Shaft Assemblies
1. Remove the traveling speed sensor (1).
2. Remove the external snap ring (3) of the creep gear shaft (4) to
the rear.
3. Take out the range gear shaft assembly (8) with the shift fork rod
(9).
4. Take out the creep shaft assembly (4) and spiral bevel pinion
shaft assembly (7) with shift fork (10) and shift fork rod (11).
5. Take out the PTO drive shaft assembly (6) and front wheel drive
shaft assembly (5).
(1) Traveling Speed Sensor
(2) Creep Gear
(3) External Snap Ring
(4) Creep Gear Shaft
(5) Front Wheel Drive Shaft
(6) PTO Drive Shaft
3-S74
TRANSMISSION
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.5 to 41.2 ft-lbs
(6) Front Wheel Drive Shaft
(7) Transmission Bearing Holder
(8) Pinion Bearing Case
(9) Taper Roller Bearing
W1054992
(7) Spiral Bevel Pinion Shaft
(8) Range Gear Shaft
(9) Shift Fork Rod
(10) Shift Fork
(11) Shift Fork Rod
W1198652
KiSC issued 02, 2007 A