L3130 · L3430 · L3830 · L4630 · L5030, WSM
GST Clutch Discs
1. Take out the clutch hub (2), clutch disc (3) and steel plate (5), (6)
from clutch case (1).
(When reassembling)
• Assemble the three steel plates (6) with plug rubbers (4) to the
front side, one steel plate (5) without plug rubber to the piston
side. (Steel plate (5), (6) are used same part.)
• Do not pile up the plug rubber (4) portion on steel plates (6) while
reassembling as shown in the figure.
(1) Clutch Case
(2) Clutch Hub
(3) Clutch Disc
Clutch Case and GST Clutch Piston
1. Remove the external snap ring (1) while pushing the spring
retainer (2) by hand press.
2. Take out the spring retainer (2), springs (3) and piston (4).
(When reassembling)
• Apply small amount of the grease to the seal rings (8) when
assemble the clutch case (7).
• Apply enough transmission fluid to the O-ring (6) and D-ring (5).
(1) External Snap Ring
(2) Spring Retainer
(3) Spring
(4) Piston
(5) D-ring
3-S68
TRANSMISSION
(4) Plug Rubber
(5) Steel Plate without Plug Rubber
W1051729
(6) O-ring
(7) Clutch Case
(8) Seal Ring
(9) Needle Bearing
W1052192
KiSC issued 02, 2007 A