wsm L503 Workshop Manual page 453

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Draft Control Feedback Rod Adjustment (If equipped)
1. Attach the test bar (5) to the top link bracket (3).
2. Start the engine and set the speed at maximum.
3. Set the position control lever (2) between 4 and 5.
4. Set the draft control lever (1) between lever guide 1 and 2.
5. Lift the test bar (5) upward until the top link bracket (4) comes in
contact with the stopper.
6. Confirm that the lower link begin to rise.
7. If the specified play is not obtained, adjust the feedback rod (3)
to A or B position.
(1) Draft Control Lever
(2) Position Control Lever
(3) Feedback Rod
(4) Top Link Bracket
(5) Test Bar
8-S13
HYDRAULIC SYSTEM
A : Insensitive
B : Sensitive
W1017519
KiSC issued 02, 2007 A