Disassembling Front Axle - wsm L503 Workshop Manual

L3130 · L3430 · L3830 · L4630 · L5030, WSM

(2) Disassembling Front Axle

Front Wheel and Front Axle Assembly
1. Check the front axle and engine are securely mounted on the
disassembly stand.
2. Loosen the front wheel mounting nuts.
3. Lift the front axle and remove the front wheels.
4. Remove the bracket (front) mounting screws and nuts.
5. Remove the bracket (rear) mounting screws and nuts.
6. Separate the front axle from front axle bracket.
(When reassembling)
IMPORTANT
• Be sure to adjust the front axle rocking force.
(See page 6-S6.)
Front wheel mounting nut
Tightening torque
Bracket mounting screw
and nut
Draining Front Axle Case Oil
1. Place oil pans underneath the front axle case.
2. Remove the drain plug (3) both sides and filling port plug (2) to
drain the oil.
3. After draining, reinstall the drain plugs (3) and filling port plug (2).
(When reassembling)
• Remove the filling port plug (2) and right and left check plugs (1).
• Fill with the new oil.
• After filling, reinstall the filling port plug (2).
Front axle
Capacity
case oil
IMPORTANT
• Use KUBOTA SUPER UDT fluid or SAE80, 90 gear oil.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7, 8.)
(1) Check Plug
(2) Filling Port Plug
6-S8
FRONT AXLE
137 N·m
14.0 kgf·m
100 ft-lbs
77.5 to 90.1 N·m
7.9 to 9.2 kgf·m
57.2 to 66.5 ft-lbs
L3130
6.5 L
L3430
6.9 U.S.qts
L3830
5.7 Imp.qts
L4630
6.0 L
L5030 6.3 U.S.qts
5.3 Imp.qts
(3) Drain Plug
W10136920
W10128890
KiSC issued 02, 2007 A