wsm L503 Workshop Manual page 167

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Shuttle Switch Connector (Manual and GST Model)
1. Remove the panel cover and steering post cover.
2. Disconnect the shuttle switch connector (1).
(1) Shuttle Switch Connector
Cruise Control Release Wire (HST Model)
1. Disconnect the cruise control release wire (1).
(When reassembling)
• Be sure to adjust the cruise control release wire (1). (See page
3-S92.)
(1) Cruise Control Release Wire
Step and Floor Seat (ROPS Model)
1. Disconnect the panel frame connector (1) from fuel tank frame.
2. Remove the step and floor seat mounting bolt and nut.
3. Dismount the step, fender, floor seat and panel frame as a unit
after checking whether there is forgetting to disconnect wiring.
(When reassembling)
• Be sure to set the washers and rubber plates of the floor seat and
step mounting bolt at an original positions as shown in figure.
• Before mounting the floor seat and step, be sure to set both the
shuttle lever rod and the shuttle arm to the neutral position, and
then connect the shuttle lever rod securely. (Manual and GST
model)
Step mounting bolt and nut
Tightening torque
Floor seat mounting bolt
and nut
(1) Panel Frame Connector
(2) Floor Seat
(3) Bolt
(4) Rubber Plate
(5) Washer
(6) Spring Washer
2-S11
CLUTCH
W1020239
W1020333
124 to 147 N·m
12.6 to 15.0 kgf·m
91.1 to 108 ft-lbs
196 to 225 N·m
20 to 23 kgf·m
145 to 166 ft-lbs
(7) Nut
(8) Step
F : Front Side
R : Rear Side
W1020698
KiSC issued 02, 2007 A