wsm L503 Workshop Manual page 275

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Seat, Seat Bracket and Lever Grips
1. Remove the seat.
2. Remove the seat bracket (1) with seat suspension (6).
3. Remove the lever grips for position control lever (2), front wheel
drive lever (5), GST lever (4) and creep shift lever (3).
4. Disconnect the differential lock rod (8).
5. Remove the lowering speed adjusting knob (7).
(1) Seat Bracket
(2) Position Control Lever
(3) Creep Shift Lever
(4) GST Lever
Electric Connector for GST
1. Disconnect the ECU connector (1).
2. Disconnect the GST lever sensor connector (2).
3. Remove the GST valve cover.
4. Disconnect the pressure switch connector (4), proportional
reducing valve connector (5), solenoid valve connector (6), oil
temperature sensor connector (8) and ground cables (7).
(1) ECU Connector
(2) GST Lever Sensor Connector
(3) Wiring Harness of GST Lever
Sensor
(4) Pressure Switch Connector
PTO Shift Wire and Electric Connector
1. Disconnect the PTO shift wire (2) at the PTO clutch valve (4).
2. Disconnect the traveling speed sensor connector (1).
(When reassembling)
• When connecting the PTO shift wire (2) to the clutch valve (4), be
sure to adjust the length of wire as follows.
1. Set the PTO shift lever to OFF (Neutral) position.
2. Loosen the lock nut (3) of wire, and connect wire to the clutch
valve lever, and then place the wire to the hook.
3. Tighten the lock nut (3) clockwise (pull the wire), and lock the nut
just before the lever moves.
(1) Traveling Speed Sensor Connector
(2) PTO Shift Wire
3-S58
TRANSMISSION
(5) Front Wheel Drive Lever
(6) Seat Suspension
(7) Lowering Speed Adjusting Knob
(8) Differential Lock Rod
W1046526
(5) Proportional Reducing Valve
Connector
(6) Solenoid Valve Connector
(7) Ground Cable
(8) Oil Temperature Sensor Connector
W1046759
(3) Lock Nut
(4) PTO Clutch Valve
W1046922
KiSC issued 02, 2007 A