wsm L503 Workshop Manual page 525

L3130 · L3430 · L3830 · L4630 · L5030, WSM
(C) Unit Checking
Checking Traveling Speed Sensor
1. Connect the panel connectors to the IntelliPanel.
2. Jack up front and rear wheels or jack up rear wheels.
Be sure to shift the front wheel drive lever to 2WD position
3. Start the engine and shift the shift lever or pedal so that the rear
wheels can be turn.
4. Measure the AC voltage between terminal 14 and terminal 3 of
connector B.
5. If the voltage is not indicated as table below, wire harness or
traveling speed sensor is faulty.
Terminal 14 to
Voltage
terminal 3
A : Connector B (16P) of Wire
Harness Side
Display Mode Switch and Travel Speed Switch
1. Check the resistance between the terminal a and terminal c while
pushing the display made switch (1).
2. It is OK if 0 Ω is indicated.
3. Check the resistance between the terminal b and terminal c while
pushing the travel speed switch (2).
4. It it OK if 0 Ω is indicated.
(1) Display Mode Switch
HST Range Gear Shift Lever Sensor Resistance
1. Measure the resistance between the terminal a and terminal b
while shifting the range gear shift lever.
2. It is OK if the resistance is smoothly changing.
(Reference)
• The maximum resistance value is 4.32 to 6.48 kΩ.
(1) Range Gear Shift Lever Sensor
9-S26
ELECTRICAL SYSTEM
Approx. AC 2.0 V
W1048327
(2) Travel Speed Switch
W1048960
W1080989
KiSC issued 02, 2007 A