wsm L503 Workshop Manual page 514

L3130 · L3430 · L3830 · L4630 · L5030, WSM
PTO Coefficient Number Input Mode (Mode "C")
(Input the numeric code number for PTO speed into the
IntelliPanel)
NOTE
• When the IntelliPanel is replaced, this operation is required.
1. Select the mode "C" (See page 9-S12 "Mode Selection").
2. "1234" is displayed (b). The existing numerical code setting will
flash.
3. To change the setting, select an appropriate input coefficient
number, referring to the tractor model
(Numeric modification)
- Each time display mode switch is pressed, the flashing number
shifts.
4. Hold down the display mode switch for more than 2 seconds with
the correct code number flashing.
IntelliPanel's memory)
5. "OK" is displayed (c) : The code number has been input
correctly.
"NG" is displayed (d) : The code number has not been input
correctly. Repeat the procedure.
6. Turn off the main switch to end the mode "C".
Operation
Tractor model
Coefficient No.
L3130, L3430, L3830,
1
L4630, L5030
L3130, L3430, L3830,
2
L4630
3
4 L5030
(a) Mode Selection Display
(b) Input Display
Error Information Reset Mode (Mode "D")
(Delete the error information from the IntelliPanel)
1. Select the mode "D" (See page 9-S12 "Mode Selection").
2. "CLEAR" is displayed (b) and "PUSH SW" is displayed (e) for 2
seconds.
3. Hold down the display mode switch for more than 2 seconds, and
the error information is deleted.
4. "OK" is displayed (d) : The IntelliPanel memory has been reset
correctly.
"NG" is displayed (e) : The resetting process has failed. Repeat
the procedure.
5. Turn off the main switch to end the mode "D".
(a) Mode Selection Display
(b) Information Display
(c) Resetting Display
9-S15
ELECTRICAL SYSTEM
(Preserve the data to
Transmission model
Manual transmission
GST
HST
– –
HST
(c) Correct Preserving Display
(d) Incorrect Preserving Display
(d) Correct Operation Display
(e) Incorrect Operation Display
KiSC issued 02, 2007 A
W1013003
W1013628