wsm L503 Workshop Manual page 112

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Outer Parts of Engine
1. Remove the hydraulic pump (7) with pump holder and regulating
valve (6).
2. Remove the radiator fan (1), belt and fan pulley (2).
3. Remove the alternator (3).
4. Remove the starter motor (4).
(When reassembling)
• Be sure to adjust the fan belt tension. (Refer to G-23.)
Alternator mounting screw
(M10)
Tightening torque
Tension adjusting screw
(M8)
(1) Radiator Fan
(2) Fan Pulley
(3) Alternator
(4) Starter Motor
(5) Fan Belt
Clutch Assembly
1. Remove the clutch from the flywheel.
(When reassembling)
• Direct the shorter end of the clutch disc boss toward the flywheel.
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of clutch disc boss.
• Install the pressure plate, nothing the position of straight pins.
IMPORTANT
• Align the center of disc and flywheel by inserting the clutch
center tool. (See page G-47.)
NOTE
• Do not allow grease and oil on the clutch disc facing.
Tightening torque Clutch mounting screws
1-S25
ENGINE
39.2 to 44.1 N·m
4.0 to 4.5 kgf·m
28.9 to 32.5 ft-lbs
17.6 to 20.6 N·m
1.8 to 2.1 kgf·m
13.0 to 15.2 ft-lbs
(6) Regulating Valve
(7) Hydraulic Pump
A : Manual Transmission and GST
Model
B : HST Model
W10169070
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.5 to 20.3 ft-lbs
W10171850
KiSC issued 02, 2007 A