wsm L503 Workshop Manual page 243

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Clutch Lever, Release Fork and Release Bearing
1. Remove the release fork mounting screws (2).
2. Draw out the clutch lever (3) to remove the release fork (1).
3. Remove the release bearing and release hub (4) together.
(When reassembling)
• Apply grease to the sliding surface of the clutch release hub.
• Apply grease to the clutch lever.
Release fork mounting
Tightening torque
screw
(1) Release Fork
(2) Release Fork Mounting Screw
Shaft Case
1. Remove the shaft case mounting screws.
2. Screw down the two M6 screws (1) into the shaft case (2) and pull
it out.
3. Take out the shaft case (2).
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the shaft case and clutch housing case.
(When replacing oil seal in shaft case)
• Install the oil seal (3) as shown in the figure, noting its direction.
• Apply grease to the oil seal (3).
(1) M6 Screw
(2) Shaft Case
3-S26
TRANSMISSION
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(3) Clutch Lever
(4) Release Hub
W10126560
(3) Oil Seal
W10128390
KiSC issued 02, 2007 A