wsm L503 Workshop Manual page 107

L3130 · L3430 · L3830 · L4630 · L5030, WSM
PTO Shift Wire, Parking Brake Cable and Connector
1. Disconnect the parking brake cable (1).
2. Disconnect the PTO shift wire (3) at the PTO clutch valve (5).
3. Disconnect the traveling speed sensor connector (2).
(When reassembling)
• Be sure to check and adjust the parking brake lever free play (see
page G-27).
• When connecting the PTO shift wire (3) to the clutch valve lever,
be sure to adjust the length of wire as follows.
1. Set the PTO shift lever to OFF (Neutral) position.
2. Loosen the lock nut (4) of wire, and connect wire to the clutch
valve lever, and then place the wire to the hook.
3. Tighten the lock nut (4) clockwise (pull the wire), and lock the nut
just before the lever moves.
(1) Parking Brake Cable
(2) Traveling Speed Sensor Connector
(3) PTO Shift Wire
Shuttle Switch Connector (Manual and GST Model)
1. Remove the panel cover and steering post cover.
2. Disconnect the shuttle switch connector (1).
(1) Shuttle Switch Connector
Cruise Control Release Wire (HST Model)
1. Disconnect the cruise control release wire (1).
(When reassembling)
• Be sure to adjust the cruise control release wire (1). (See page
3-S92.)
(1) Cruise Control Release Wire
1-S20
ENGINE
(4) Lock Nut
(5) PTO Clutch Valve
W1064487
W1064666
W1065090
KiSC issued 02, 2007 A