wsm L503 Workshop Manual page 517

L3130 · L3430 · L3830 · L4630 · L5030, WSM
GST Shift Shock Fine-adjustment Mode (Mode "G")
(Adjusting the clutch engaging interval)
NOTE
• When the sense of shifting shock is not suitable, shifting
shock can be changed by this adjustment.
1. While holding down the both switches at once, start the engine.
2. Select mode "G" (See page 9-S12 "Mode Selection").
3. "SHOCK" is displayed (b) first and then the numerical code
setting is displayed (c).
The number "−9" through "+9" can be displayed. This has been
factory-adjusted to "0".
4. Setting;
- For lighter shifting shock;
Press the travel speed switch to reduce the number.
- For higher shifting shock;
Press the display mode switch to increase the number.
5. Move the tractor to confirm the shifting shock.
6. Turn off the key. Then setting will be put in memory.
NOTE
• If the shift shock has been adjusted but no remarkable effect
can be felt, keep the setting at "0".
(a) Mode Selection Display
(b) Information Display
Error Information Display Mode (Mode "H")
(Confirming or Reviewing the Error Information)
1. Select mode "H" (See page 9-S12 "Mode Selection").
2. If there is not error information in memory, "NO ERROR" is
displayed (b).
If there is error information in memory, its information is displayed
(c).
3. If there are two or more error information readouts, presses the
display mode switch and the stored information can be reviewed
one by one.
4. Turn off the main switch to end the mode "H".
NOTE
• Even if a problem has been corrected or repaired, the
information is displayed until it is deleted.
• Refer to "Error Information Reset Mode (Mode "D") for
deleting the error information.
(a) Mode Selection Display
9-S18
ELECTRICAL SYSTEM
(c) Setting Number Display
W1020862
(b) Information Display
W1014747
KiSC issued 02, 2007 A