wsm L503 Workshop Manual page 237

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Steering Joint, Brake Pedal Rod and Electric Wiring
1. Remove the tank frame support (1).
2. Remove the universal joint bolt (7) and steering joint support (3),
and then remove the steering joint (2).
3. Disconnect the hand accelerator wire and foot accelerator wire
(4).
4. Disconnect the wiring connectors for engine stop solenoid (5)
engine tachometer sensor (6) and glow plug.
5. Disconnect the brake pedal rod.
(When reassembling)
• When accelerator wire is installed, adjust the wire length as hit
both the idling speed adjusting bolt and the maximum speed
adjusting bolt by lever within the stroke of the accelerator lever.
• Set the steering joint (2) by the joint support (3) so that the
steering wheel is turned lightly.
• Be sure to check and adjust the brake pedal free travel. (See
page G-18.)
(1) Tank Frame Support
(2) Steering Joint
(3) Steering Joint Support
(4) Accelerator Wire
Clutch Rod, Brake Pedal Rod and Electric Wiring
1. Disconnect the brake pedal rod (5) and clutch pedal rod (4).
2. Disconnect the wiring connectors for alternator (1), coolant
temperature sensor (7), oil pressure switch (2), fuel unit (3),
starter motor (6) and battery.
3. Remove the clamps and ground earth of wiring harness and
collect wiring harness to the step.
(When reassembling)
• Be sure to check and adjust the clutch and brake pedal free
travel. (See page G-18, 24.)
(1) Alternator
(2) Oil Pressure Switch
(3) Fuel Unit
(4) Clutch Pedal Rod
3-S20
TRANSMISSION
(5) Engine Stop Solenoid
(6) Engine Tachometer Sensor
(7) Universal Joint Bolt
W1014002
(5) Brake Pedal Rod
(6) Starter Motor
(7) Coolant Temperature Sensor
W1014368
KiSC issued 02, 2007 A