wsm L503 Workshop Manual page 376

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Bevel Gear Case and Front Gear Case (for L5030)
1. Remove the bevel gear case mounting screws.
2. Remove the bevel gear case (3) and front gear case (4) as a unit
from the front axle case (1).
(When reassembling)
• Apply grease to the O-ring (2) and take care not to damage it.
• Do not interchange right and left bevel gear case assemblies.
Bevel gear case mounting
Tightening torque
screw
(1) Front Axle Case
(2) O-ring
Axle Flange and Front Gear Case
1. Remove the axle flange mounting screws.
2. Remove the axle flange (1).
(When reassembling)
• Apply grease to the O-ring (2) of axle flange.
• Tighten the axle flange mounting screws and nuts diagonally in
several steps.
Tightening Axle flange mounting
torque screw and nut
(1) Axle Flange
Bevel Gear and Bevel Gear Shaft
1. Remove the plug (5).
2. Remove the internal snap ring (4) and shim (3).
3. Tap out the bevel gear (2) with ball bearing.
4. Draw out the bevel gear shaft (1).
(1) Bevel Gear Shaft
(2) Bevel Gear
(3) Shim
6-S10
FRONT AXLE
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123 to 145 ft-lbs
(3) Bevel Gear Case
(4) Front Gear Case
W10155120
L3130
23.6 to 27.5 N·m
L3430
2.4 to 2.8 kgf·m
L3830
1734 to 20.3 ft-lbs
L4630
29.4 to 34.3 N·m
L5030 3.0 to 3.5 kgf·m
21.7 to 25.3 ft-lbs
(2) O-ring
W10156660
(4) Internal Snap Ring
(5) Plug
W10159240
KiSC issued 02, 2007 A