wsm L503 Workshop Manual page 250

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Clutch Case
1. Remove the external snap ring (1).
2. Remove the clutch case (7) and brake disc (5).
(When reassembling)
• Direct the contact part of the brake disc (5) to the brake plate (6).
• Apply small amount of the grease to the seal rings (8).
(1) External Snap Ring
(2) Collar
(3) Bearing Holder
(4) Collar
Brake Plate
1. Remove the brake plate mounting screws (3) and then take out
the brake plate (4) and the springs (2).
(When reassembling)
• Apply liquid lock (Three Bond 1372 or equivalent) to the brake
plate mounting screws (3).
• Apply grease to the O-rings (5), and be sure to install the three
O-rings (5).
Brake plate mounting
Tightening torque
screw
(1) Clutch Case
(2) Spring
(3) Brake Plate Mounting Screw
Piston
1. Press the washer (7) lightly by the hand press, using the hand
made jig. (Refer to the figure left.)
2. Remove the external snap ring (3), washer (7) and spring (6).
3. Draw out the piston (5).
(When reassembling)
• Apply enough transmission fluid to seal rings (4) and (8).
(1) Clutch Case
(2) Jig
(3) External Snap Ring
(4) Seal Ring
(5) Piston
3-S33
TRANSMISSION
(5) Brake Disc
(6) Brake Plate
(7) Clutch Case
(8) Seal Ring
W10164510
9.8 to 11.3 N·m
1.00 to 1.15 kgf·m
7.2 to 8.3 ft-lbs
(4) Brake Plate
(5) O-ring
W10167880
(6) Spring
(7) Washer
(8) Seal Ring
A : 41 mm (1.6 in.)
W10169240
KiSC issued 02, 2007 A