wsm L503 Workshop Manual page 292

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Disassembling Shaft Assemblies
1. Disassemble the each shaft referring to the figure.
(1) 49T-19T-20T Gear
(2) Range Gear Shaft
(3) 17T Gear
(4) 35T Gear
(5) 50T Gear
(6) 18T Gear (L4630)
17T Gear (L5030)
(7) Spiral Bevel Pinion Shaft
Differential Lock Shift Fork
1. Tap out the left side spring pin (4).
2. Remove the cotter pin and take out the clevis pin (3).
3. Draw out the differential lock fork shaft (1) and take out the
differential lock shift fork (2).
(When reassembling)
• Apply grease to the left and right oil seals on the transmission
case.
• Insert the clevis pin (3) from the top and install the washer and
cotter pin.
• Tap in the spring pin (4) so that its split portion a may face
outward as shown in the figure.
(1) Differential Lock Fork Shaft
(2) DIfferential Lock Shift Fork
(3) Clevis Pin
(4) Spring Pin
3-S75
TRANSMISSION
(8) 44T Gear
(9) Shifter for Creep Shift
(10) Creep Shaft
(11) 29T-30T Gear ( L4630)
29T-32T Gear (L5030)
(12) PTO Drive Shaft
(13) Front Wheel Drive Shaft
(14) 24T Shifter Gear
W1055343
a : Split Portion
W12034180
KiSC issued 02, 2007 A