wsm L503 Workshop Manual page 380

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Differential Gear
1. Remove the differential case cover mounting screws (9) and then
take out the differential case cover (5), ball bearing (6) and spiral
bevel gear (7) as a unit.
2. Remove the external snap ring (8), and then remove the ball
bearing (6) and spiral bevel gear (7) as a unit with a puller.
3. Remove the straight pin (13).
4. Pull out the pinion shaft (10) and take out the differential pinions
(4) and differential side gears (12).
(When reassembling)
• Apply molybdenum disulfide (Three Bond 1901 or equivalent) to
the inner circumferential surface of the differential side gears (12)
and differential pinions (4).
Tightening Differential case cover
torque mounting screw
(1) Shim
(2) Differential Case
(3) Thrust Collar
(4) Differential Pinion
(5) Differential Case Cover
(6) Ball Bearing
(7) Spiral Bevel Gear
6-S14
FRONT AXLE
L3130
48.0 to 58.8 N·m
L3430
4.9 to 6.0 kgf·m
L3830
35.4 to 43.4 ft-lbs
L4630
60.8 to 70.6 N·m
L5030 6.2 to 7.2 kgf·m
44.8 to 52.1 ft-lbs
(8) External Snap Ring
(9) Differential Case Cover Mounting
Screw
(10) Pinion Shaft
(11) Shim
(12) Differential Side Gear
(13) Straight Pin
W10174670
KiSC issued 02, 2007 A