wsm L503 Workshop Manual page 288

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Rear Hydraulic Block and Lift Arm Support
1. Remove the GST delivery pipe. (Refer to 3-S59.)
2. Loosen the main delivery pipe support screw and disconnect the
main delivery pipe at the rear hydraulic block (1). (Refer to 3-
S59.)
3. Remove the rear hydraulic block (1), cover (2) and lift arm
support (3) as a unit.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the differential case and cover (2).
Joint bolt for main delivery
pipe to rear hydraulic block
Tightening torque
Joint bolt for GST delivery
pipe
(1) Rear Hydraulic Block
(2) Cover
Rear Axle
1. Separate the rear axle case from brake case.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the rear axle and brake case.
Rear axle case
Tightening
mounting
torque
screw and nut
3-S71
TRANSMISSION
49 to 69 N·m
5.0 to 7.0 kgf·m
36.1 to 50.6 ft-lbs
34 to 39 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 ft-lbs
(3) Lift Arm Support
48.1 to 55.9 N·m
M10 screw
4.9 to 5.7 kgf·m
and nut (7T)
35.4 to 41.2 ft-lbs
24.5 to 31.4 N·m
Stud bolt 2.5 to 3.2 kgf·m
18.1 to 23.1 ft-lbs
60.8 to 70.6 N·m
M10 nut (9T) 6.2 to 7.2 kgf·m
44.9 to 52.1 ft-lbs
77.5 to 90.2 N·m
M12 screw 7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
KiSC issued 02, 2007 A
W1054122
W1054206