wsm L503 Workshop Manual page 100

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Draining the Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1).
(When refilling)
• Fill up from filling port after removing the filling plug (2) until
reaching the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the oil
level again, add the fluid to prescribed level if it is not correct
level.
L3130
L3430
Transmission fluid L3830
capacity L4630
L5030
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7, 8.)
• Do not mix different brands of fluid together.
(1) Drain Plugs
(2) Filling Plug
(3) Dipstick
1-S13
ENGINE
42 L
11.1 U.S.gals
9.2 Imp.gals
43 L
11.4 U.S.gals
9.5 Imp.gals
45 L
11.9 U.S.gals
9.9 Imp.gals
(A) Oil level is acceptable within this
range.
W1014221
KiSC issued 02, 2007 A