wsm L503 Workshop Manual page 137

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Camshaft Side Clearance
1. Set a dial indicator with its tip on the camshaft.
2. Measure the side clearance by moving the cam gear to the front
and rear.
3. If the measurement exceeds the allowable limit, replace the
camshaft stopper.
Factory spec.
Camshaft side
clearance
Allowable limit
Balancer Shaft Side Clearance (for V2203-M and V2403-M)
1. Set a dial indicator with tip on the balancer shaft.
2. Measure the side clearance by moving the balancer shaft to the
front and rear.
3. If the measurement exceeds the allowable limit, replace the
balancer shaft.
Factory spec.
Side clearance of
balancer shaft
Allowable limit
1-S50
ENGINE
0.07 to 0.22 mm
0.0028 to 0.0087 in.
0.30 mm
0.0118 in.
W1030012
0.07 to 0.22 mm
0.0028 to 0.0087 in.
0.3 mm
0.0118 in.
W1030111
KiSC issued 02, 2007 A