wsm L503 Workshop Manual page 37

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Changing Transmission Fluid
CAUTION
• Be sure to stop the engine checking and changing the
transmission fluid.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Place an oil pan under the tractor.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. After draining, screw in the drain plugs.
5. Fill new oil from filling port after removing the filling plug (2) up to
the upper line of the dipstick (3).
6. After running the engine for a few minutes, stop it and check the
oil level again, if low, add oil prescribed level.
IMPORTANT
• Use only multi-grade transmission oil. Use of other oils may
damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7, 8.)
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for a
few minutes to prevents damage to the transmission.
• Do not mix different blands oil together.
L3130, L3430
Transmission fluid
L3830, L4630
capacity
L5030
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
G-17
G GENERAL
42 L
11.1 U.S.gals
9.2 Imp.gals
43 L
11.4 U.S.gals
9.5 Imp.gals
45 L
11.9 U.S.gals
9.9 Imp.gals
(A) Oil level is acceptable within this
range.
W1068655
KiSC issued 02, 2007 A