wsm L503 Workshop Manual page 314

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Hydraulic Pipes
1. Remove the main delivery pipe 1 (5).
2. Disconnect the main delivery pipe 2 (1) at the rear hydraulic block
(6) and return pipe (2) at the mid case, and then remove the front
hydraulic block (4) with pipes and bracket as a unit.
3. Remove the suction pipe (3) with oil filter (7).
4. Disconnect the oil cooler pipe (8) at the clutch housing.
5. Remove the brake rods (9).
(When reassembling)
Joint bolt for main delivery
pipe 1 to front hydraulic
block
Joint bolt for main delivery
pipe 2 to rear hydraulic
block
Tightening torque
Cap nut for return pipe to
mid case
Joint bolt for oil cooler pipe
(1) Main Delivery Pipe 2
(2) Return Pipe
(3) Suction Pipe
(4) Front Hydraulic Block
(5) Main Delivery Pipe 1
Propeller Shaft
1. Slide the propeller shaft cover (4) and (8) after removing the
screws (7).
2. Tap out the spring pins (2), (6) and slide the couplings (1), (5) and
then remove the propeller shaft with covers (4), (8).
(When reassembling)
• Apply grease to the splines of propeller shaft 1 (3).
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft 1
(4) Propeller Shaft Cover
3-S97
TRANSMISSION
49 to 69 N·m
5.0 to 7.0 kgf·m
36.1 to 50.6 ft-lbs
49 to 69 N·m
5.0 to 7.0 kgf·m
36.1 to 50.6 ft-lbs
49 to 69 N·m
5.0 to 7.0 kgf·m
36.1 to 50.6 ft-lbs
34 to 39 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 ft-lbs
(6) Rear Hydraulic Block
(7) Hydraulic Oil Filter
(8) Oil Cooler Pipe
(9) Brake Rod
W1067018
(5) Coupling
(6) Spring Pin
(7) Screws
(8) Propeller Shaft Cover
W1254425
KiSC issued 02, 2007 A