wsm L503 Workshop Manual page 536

L3130 · L3430 · L3830 · L4630 · L5030, WSM
(D) Starter and Starter Relay
HST Pedal Switch (For HST Model)
1. Disconnect the HST neutral switch connector.
2. Remove the HST neutral switch (1).
3. Push the switch and measure the resistance between terminal 1
and 2, and between terminal 3 and 4.
4. If 0 Ω is not indicated, switch is faulty.
Terminal 1 - 2
Resistance while
pushing the switch
Terminal 3 - 4
(1) HST Neutral Switch
Clutch Pedal Switch (For HST Model)
1. Remove the panel cover.
2. Disconnect the clutch pedal switch connector (2).
3. Measure the resistance between connector terminals while
pushing the clutch pedal switch.
4. If 0 Ω is not indicated, switch is faulty.
(1) Clutch Pedal Switch
Starter Motor B Terminal Voltage
1. Measure the voltage between the B terminal and chassis.
2. If the voltage differs from the battery voltage, check the battery's
cable.
Voltage Factory spec.
9-S37
ELECTRICAL SYSTEM
0 Ω
(2) Switch Connector
W1045046
(2) Clutch Pedal Switch Connector
W1045306
Approx. battery voltage
W1016256
KiSC issued 02, 2007 A