wsm L503 Workshop Manual page 273

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Steering Joint, Brake Pedal Rod and Electric Wiring
1. Remove the tank frame support (2).
2. Remove the universal joint bolt (10) and steering joint support (6),
and then remove the steering joint (1).
3. Disconnect the hand accelerator wire and foot accelerator wire
(7).
4. Disconnect the wiring connectors for engine stop solenoid (8),
engine tachometer sensor (9) and glow plug.
5. Disconnect the heater hoses (3), and then reconnect their hoses
to make loop.
NOTE
• Put a mark to the each heater hose before disconnecting.
6. Disconnect the wiring connector for window washer tank (4) and
compressor 1P connector (5).
7. Disconnect the brake pedal rod.
(When reassembling)
• When accelerator wire is installed, adjust the wiring length as hit
both the idling speed adjusting bolt and the maximum speed
adjusting bolt by lever within the stroke of the accelerator lever.
• Set the steering joint (1) by the joint support (6) so that the
steering wheel is turned lightly.
• Be sure to check and adjust the brake pedal free travel. (See
page G-18.)
(1) Steering Joint
(2) Tank Frame Support
(3) Heater Hose
(4) Window Washer Tank
(5) 1P Connector
Clutch Rod, Brake Pedal Rod and Electric Wiring
1. Disconnect the brake pedal rod (6) and clutch rod (4).
2. Disconnect the wiring connectors for alternator (1), coolant
temperature sensor (9), oil pressure switch (2), fuel unit (3),
starter motor (7) and battery.
3. Remove the clamps and ground earth of wiring harness and
collect wiring harness to the step or cabin.
4. Remove the clamps (8) of A/C hoses (5). (A/C model only.)
(When reassembling)
• Be sure to check and adjust the clutch and brake pedal free
travel. (See page G-18, 24.)
(1) Alternator
(2) Oil Pressure Switch
(3) Fuel Unit
(4) Clutch Rod
(5) A/C Hoses
3-S56
TRANSMISSION
(6) Steering Joint Support
(7) Accelerator Wire
(8) Engine Stop Solenoid
(9) Engine Tachometer Sensor
(10) Universal Joint Bolt
W1033546
(6) Brake Pedal Rod
(7) Starter Motor
(8) Clamps
(9) Coolant Temperature Sensor
W1033897
KiSC issued 02, 2007 A