wsm L503 Workshop Manual page 101

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Draining Coolant
CAUTION
• Never remove the radiator cap until coolant temperature is
well below its boiling point. Then loosen cap slightly to the
stop to relieve any excess pressure before removing cap
completely.
1. Stop the engine and let cool down.
2. Loosen the drain plug (3) to drain the coolant.
3. Remove the radiator cap (1) to completely drain the coolant.
4. After all coolant is drained, retighten the drain plug (3).
(When refilling)
• Fill the coolant between the "FULL" and "LOW" marks of
recovery tank (2).
L3130
L3430
L3830 (ROPS)
L4630 (ROPS)
Coolant capacity (with
recovery tank)
L3830 (CABIN)
L4630 (CABIN)
L5030
(1) Radiator Cap
(2) Recovery Tank
(3) Drain Plug
ROPS (Center ROPS Type)
1. Remove the upper frame (1) from ROPS lower frame (2).
2. Disconect the light connectors.
3. Remove the shields (3).
4. Remove the lower frames (2).
(When reassembling)
NOTE
• Do not firmly tighten all screws until most components are
attached.
Lower frame mounting
Tightening torque
screw
(1) Upper Frame
(2) Lower Frame
Battery, Front Grill, Skirt and Bonnet
1. Open the bonnet and disconnect the battery negative cable.
2. Disconnect the head light connector and remove the front grill (4).
3. Remove the left and right side skirts (3).
4. Disconnect window washer hoses (2). (Cabin model only.)
5. Remove the bonnet (1).
NOTE
• When disconnecting the battery cords, disconnect the
negative cord first, when connecting, positive cord first.
(1) Bonnet
(2) Window Washer Hose
1-S14
ENGINE
6.0 L
6.3 U.S.qts
5.3 Imp.qts
7.5 L
7.9 U.S.qts
6.6 Imp.qts
8.7 L
9.2 U.S.qts
7.7 Imp.qts
9.2 L
9.7 U.S.qts
8.1 Imp.qts
A : FULL
B : LOW
W10314120
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 ft-lbs
(3) Shield
W1031307
(3) Skirt
(4) Front Grill
W1057856
KiSC issued 02, 2007 A