Disassembling And Assembling - wsm L503 Workshop Manual

L3130 · L3430 · L3830 · L4630 · L5030, WSM

(2) Disassembling and Assembling

(A) Clutch Housing
Draining the Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1).
(When refilling)
• Fill up from filling port after removing the filling plug (2) until
reaching the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the oil
level again, add the fluid to prescribed level if it is not correct
level.
L4630
Transmission fluid
capacity
L5030
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7, 8.)
• Do not mix different brands of fluid together.
(1) Drain Plugs
(2) Filling Plug
(3) Dipstick
Battery, Front Grill, Skirt and Bonnet
1. Open the bonnet and disconnect the battery negative cable.
2. Disconnect the head light connector and remove the front grill (4).
3. Remove the left and right side skirts (3).
4. Disconnect window washer hoses (2). (Cabin model only.)
5. Remove the bonnet (1).
NOTE
• When disconnecting the battery cords, disconnect the
negative cord first, when connecting, positive cord first.
(1) Bonnet
(2) Window Washer Hose
3-S55
TRANSMISSION
43 L
11.4 U.S.gals
9.5 Imp.gals
45 L
11.9 U.S.gals
9.9 Imp.gals
(A) Oil level is acceptable within this
range.
W1166268
(3) Skirt
(4) Front Grill
W1033112
KiSC issued 02, 2007 A