To" (Destination) Setting - Icom ID-31A Advanced Instructions

Previous view
■ "TO" (Destination) setting
The destination repeater or station must be set to "TO"
when you transmit a call in the DV mode.
You have eight ways to set the destination.
Click the title as shown below to jump to the specified
page.
1: Using [DIAL]
Select the repeater or station preset in your trans-
ceiver by rotating [DIAL]. (Invalid when "CQCQCQ"
is selected.)
To make a CQ call in your local area
2: "Local CQ" setting (p. 3-2)
Set "CQCQCQ" to "TO"
To make a CQ call to another area
3: "Gateway CQ" setting (p. 3-3)
Select a repeater from the repeater list.
To make a call to a specific station
4: "Your Call Sign" setting (p. 3-14)
Select the station call sign in the Your Call Sign
memory.
When the destination data is stored in the RX History
5: Setting from the RX History (p. 3-15)
When you receive a call, the calling station data is
stored in the RX History.
You can select the destination from the record.
When the destination data is stored in the TX History
6: Setting from the TX History (p. 3-16)
When you transmit a call, the destination repeater or
station data is stored in the TX History.
You can select the destination from the record.
To directly input the destination station call sign
7: Direct Input (UR) (p. 3-17)
Directly input the destination station call sign.
To directly input the destination repeater call sign
8: Direct Input (RPT) (p. 3-18)
Directly input the destination repeater call sign.
[TO SELECT] screen
How to change the repeater group:
When "Local CQ" or "Gateway CQ" is
selected, you can change the repeater
group.
➥ While in the DR mode, push
display the quick menu, and then push
D-pad(
• You can change the repeater group us-
ing D-pad()
3-13
DR MODE <BASIC>
When using [DIAL]
Means this repeat-
er is programmed
as the 52nd of the
635 repeaters in
the repeater list.
) to select [Group Select].

3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
to
19
20
21