To" (Destination) Setting - Icom ID-5100A Full Manual

Previous view
6
D-STAR OPERATION <BASIC>

"TO" (Destination) setting

The destination repeater or station must be set in "TO"
when you make a call in the DV mode.
You have eight ways to set the destination.
Setting by rotating [DIAL]
Rotate [DIAL] to select the repeater or Your Call
Sign that is displayed on the DR screen. (This op-
eration is disabled when "CQCQCQ" is set.)
To make a Local Area CQ call
"Local CQ" setting (p. 6-13)
Set "CQCQCQ" in "TO" (Destination).
To make a Gateway CQ call
"Gateway CQ" setting (p. 6-14)
Select a repeater from the repeater list, if you want
to make a Gateway call.
To make a call through a reflector
"Reflector" setting (p. 6-31)
Select a reflector you want to call through.
To make a call to a specific station
"Your Call Sign" setting (p. 6-25)
Select the station call sign in the Your Call Sign
memory.
How to change the repeater group:
When "Local CQ" or "Gate-
way CQ" is selected, you can
change the repeater group.
While in the DR screen,
➥
touch [QUICK], and then
touch "Group Select."
For your reference:
After you receive the individual station or repeater's
signal, the call sign can be captured by holding down
the Call Sign Capture key ([RX>CS]), and you can
quickly and easily reply to a call.
To select from RX History
Setting from RX History (p. 6-26)
When you receive a call, the repeater or caller sta-
tion data is stored in RX History.
You can select the destination from the record.
To select from TX History
Setting from TX History (p. 6-27)
When you make a call, the destination repeater or
called station data is stored in TX History.
You can select the destination from the record.
[TO SELECT] screen
To directly enter the destination station call sign
Direct Input (UR) (p. 6-28)
Directly enter the destination station's call sign.
To directly enter the destination repeater call sign
Direct Input (RPT) (p. 6-29)
Directly enter the destination repeater's call sign.
6-23