To" (Destination) Setting - Icom ID-31E PLUS Basic Manual

D-STAR OPERATION
■ "TO" (Destination) setting
Set by rotating [DIAL]:
Rotate [DIAL] to select a repeater or Your Call Sign that
is displayed on the DR screen. (This operation is disabled
when "CQCQCQ" is set.)
To make a Local Area CQ call:
Set "CQCQCQ" in "TO"
(Destination).
To make a call to a specific
station:
Select the station call sign in the
Your Call Sign.
To select from RX History:
When you receive a call, the
caller station data is saved in
RX History. You can select the
destination from the record.
To directly enter the
destination station call sign:
Directly enter the destination
station's call sign.
61
D-STAR GUIDE
TIP: After you receive the individual station or repeater's
signal, the call sign can be captured by holding down the
Call Sign Capture key ([RX>CS]), and you can quickly
and easily reply to a call.
To make a Gateway CQ call:
Select a repeater from the
repeater list, if you want to make
a Gateway call.
To make a call through a
reflector:
Select a reflector that is
connected to the repeater you
want to call through.
To select from TX History:
When you make a call, the
destination repeater or called
station data is saved in TX
History. You can select the
destination from the record.
To directly enter the
destination repeater call sign:
Directly enter the destination
repeater's call sign.