I Memory Bank Setting - Icom IC-2820H Instruction Manual

5
MEMORY OPERATION

I Memory bank setting

qPush the desired band's [M/CALL•MW] several times to
select memory mode, then rotate the same band's [DIAL]
to select the desired memory channel.
wPush and hold the same band's [M/CALL•MW] for 1 sec.
• "X" and memory number indication blinks.
ePush [SEL](V/MHz•SCAN)
lect "BANK" setting stand-by condition.
• "X" indicator blinks.
r Push [EDIT](M/CALL•MW)
• "X" and 1st digit blink.
tRotate the same band's [DIAL] to select the desired bank
group.
• A to Z bank groups available.
yPush [>](M/CALL•MW)
select the desired bank channel.
• "X" and last 2 digits blink.
41
several times to se-
(Left band's)
to edit.
(Right band's)
then rotate [DIAL] to
(Left band's)
uPush [BACK](V/MHz•SCAN)
initial and channel number.
• "X" indicator blinks.
iPush and hold [S.MW](M/CALL•MW)
to overwrite the memory channel to store the memory bank
settings.
oRepeat steps q to i to set another memory channel into
the same or another bank.
to set the bank
(Right band's)
for 1 sec.
(Left band's)