5.3 Adjusting Stop/Cut Position of the Media
If the stop/print position of the label is incorrect, adjust with the adjustment mode screen.
• Stop position of the label in Dispenser mode.
The regular position is to let the label stay about
1 mm (0.04") on the liner.
• Cut position when using the label.
The regular cut position is between labels (only
cut on the liner).
Do not cut on the label because the glue
attached to the blade decreases the
performance of the cutter.
For more details on the procedures to adjust the stop/cut position of the media, refer to
The Adjustment of Media Stop
Position.
5 Cleaning and Adjustment of the Printer
Cut Position
Cut Position
Section 7.4.2
CL4NX Operator Manual
Stop
position
Label
Liner
Label
173