Configuring A Call Route For Inbound Calls - HP MSR SERIES Configuration Manual

Hide thumbs Also See for MSR SERIES:

Table of Contents

Mid-call Signal

Configuring a call route for inbound calls

Select Voice Management > Call Route from the navigation tree, and click Add to access the call route

configuration page. Specify the call route type as SIP.

For more information about call route, see "Local number and call route" and "Basic settings".

SIP trunk configuration examples

Configuring a SIP server group with only one member server

Network requirements

The enterprise private network has a SIP trunk device. Router A is a private network device, and Router

B is a public network device. Configure a SIP server group with only one member server so that all calls

between the private network and public network are made through the SIP trunk device.

Figure 700 Network diagram

Configuring Router A

# Configure a local call number.

Remote process—If the session timer mechanism is initiated by

the calling party, and the called party also supports this

mechanism, you can select this option to enable the called party

to process the session update information. Otherwise, the session

timer mechanism only works between the calling party and the

SIP trunk device. The interval for sending session update requests

is negotiated by endpoints. For more information, see RFC 4028.

Local process—The SIP trunk device processes the update

messages rather than transparently pass them to the peer end.

By default, the Local option is selected.

Show Quick Links

Table of Contents