HP MSR SERIES Configuration Manual page 407

Item
Website Address
Default Page
Website Matching Mode
Enable page protection
4. Set whether to enable single login:
To enable single login, select the box before the Single login field to expand the configuration area
(as shown in Figure
166.
After you enable single login and configure single login parameters, when a user accesses the
resource through the SSL VPN service interface, the user is redirected to the specified website if the
user's username and password for accessing the website are the same as those for logging in to
the SSL VPN service interface.
5. Click Apply.
Figure 392 Configuring single login
Description
Specify the Website address for providing Web services. It must start with
http:// and end with /, for example, http://www.domain.com/web1/.
The website address can be an IP address or a domain name. If you specify
a domain name, make sure you configure domain name resolution on
Advanced > DNS Setup > DNS Configuration.
Specify the home page to be displayed after an SSL VPN user logs in. For
example, index.htm.
Specify website matching patterns to determine which webpages a user can
access through the website specified in the Website Address field.
Website matching supports fuzzy match based on wildcard *. Use vertical
bars (|) to separate multiple matching patterns.
Assume that you have specified a website address in the Website Address
field. To allow access to specific webpages provided at the website, for
example, the webpages www.domain1.com, www.domain2.com,
www.domain2.org, and www.domain2.edu, you can specify
www.domain1.com|www.domain2.* as the matching patterns.
Select this box to enable page protection.
With page protection enabled, a login user cannot capture screen shots,
save pages, or printing pages.
392), and then configure the single login parameters as described in
390
Table