Figure 382 Adding a static route from Router A through interface Tunnel 0 to Group 2
Configuring Router B
1.
Configure an IPv4 address for interface Ethernet 0/0:
a.
Select Interface Setup > WAN Interface Setup from the navigation tree.
b.
Click the
in
Figure
c.
Select Manual for Connect Mode.
d.
Enter IP address 10.1.3.1.
e.
Select IP mask 24 (255.255.255.0).
f.
Click Confirm.
Figure 383 Configuring interface Ethernet 0/0
2.
Configure an IP address for interface Ethernet 0/1, the physical interface of the tunnel:
icon for interface Ethernet 0/0 and then perform the configurations shown
383.
380