Configuring An Snmp Community - HP MSR SERIES Configuration Manual

Figure 256 Adding rules to an SNMP view
You can also click the
and then you can enter the page to modify the view.

Configuring an SNMP community

1. Select Advanced > SNMP from the navigation tree, then click the Community tab to enter the page
as shown in
Figure 257 Configuring an SNMP community
2. Click Add to enter the Add SNMP Community page.
Figure 258 Creating an SNMP Community
3. Configure the SNMP community, as shown in
icon corresponding to the specified view on the page as shown in
Figure 257.
Table 124.
256
Figure 253,