HP MSR SERIES Configuration Manual page 547

Item Description
Route Description Enter the description of the call route.
SIP
Call Route Type
Trunk
Select one of the following transport layer protocols:
•
Transport Layer
•
Protocol for Call
Route
•
By default, UDP is selected.
•
URL Scheme for
•
Call Route
By default, the SIP scheme is selected.
•
•
Register Function
The trunk routing mode supports register function. Authentication related options and their
meanings are the same as those of local number and therefore are not included here.
•
Jitter-buffer
Adaptive Mode
•
Jitter-buffer Initial Specify the initial duration for buffering voice packers received from the IP side. The
Delay default value is 30 seconds.
Jitter-buffer Specify the maximum duration for buffering voice packers received from the IP side. The
Maximum Delay default value is 160 seconds.
Status Enable or disable the call route.
Proxy Server
IP Routing
Binding Server
Group
Trunk Route Line
UDP.
TCP.
TLS.
SIP—Specifies the SIP scheme.
SIPS—Specifies the SIPS scheme.
Enable. After you select the Enable option, you can configure the authentication
related options.
Disable.
IMPORTANT:
Enable—Select this option to buffer the voice packers received from the IP side, so that
the received voice packets can be played out evenly.
Disable—Select this option to not buffer the voice packers received from the IP side.
530
Use a SIP proxy server to complete
calling.
Use the SIP protocol to perform direct
calling. It you select this option, you must
provide the destination address and port
number.
Select a server group from the Server
Group list. You can add SIP server
groups into the list in Voice
Management > Call Connection > SIP
Server Group Management.
Select a trunk routing line from the list
that displays all available voice
subscriber lines.
Required to
use one
method.