Configuring user-based load sharing
You can configure user-based load sharing through the Web interface.
Overview
A routing protocol can have multiple equal-cost routes to the same destination. These routes have the
same preference, and are all used to accomplish load sharing if no route with a higher preference is
available.
The device supports user-based load sharing based on the user information (source IP addresses) of
packets.
Configuration procedure
1.
Select Advanced > User-based-sharing from the navigation tree.
The user-based load sharing page appears.
Figure 188 User-based load sharing
Click the
2.
The Modify configuration page appears.
Figure 189 Modifying configuration
3.
Configure the parameters as described in
icon of an interface.
Table
100.
184