Snmpv3 Configuration Example - HP MSR SERIES Configuration Manual

3. Create a read and write community and name it private.
For more information about configuring the NMS, see the NMS manual.
Verifying the configuration
After the configuration, an SNMP connection is established between the NMS and the agent. The
•
NMS can get and configure the values of some parameters on the agent through MIB nodes.
Shut down or bring up an idle interface on the agent, and the NMS receives the corresponding
•
trap.

SNMPv3 configuration example

Network requirements
As shown in
of the agent (1.1.1.1/24), and the agent automatically sends traps to report events to the NMS.
The NMS and the agent perform authentication when they set up an SNMP session. The authentication
algorithm is MD5 and the authentication key is authkey. The NMS and the agent also encrypt the SNMP
packets between them by using the DES algorithm and the privacy key prikey.
Figure 272 Network diagram
Configuring the agent
1. Enable SNMP:
a. Select Advanced > SNMP from the navigation tree, and you will enter the Setup page. Perform
the following configuration as shown in
b. Select the Enable radio box.
c. Set the SNMP version to v3.
d. Click Apply.
Figure 272, the NMS (1.1.1.2/24) uses SNMPv3 to monitor and manage the interface status
Figure 273.
266