Configuring A Rule For An Ethernet Frame Header Acl - HP MSR SERIES Configuration Manual

Hide thumbs Also See for MSR SERIES:

Table of Contents

TCP/UDP Port

Configuring a rule for an Ethernet frame header

Select Advanced > QoS Setup > ACL IPv4 from the navigation tree and then select the Link Config tab to

enter the rule configuration page for an Ethernet frame header IPv4 ACL.

TCP Connection

Select this box to make the rule match packets used for

establishing and maintaining TCP connections.

These items are available only when you select 6 TCP from the

Protocol list.

A rule with this item configured matches TCP connection packets

with the ACK or RST flag.

Select the operators and, enter the source port numbers and

destination port numbers as required.

These items are available only when you select 6 TCP or 17 UDP

from the Protocol list.

Different operators have different configuration requirements for

the port number fields:

Not Check—The following port number fields cannot be

Range—The following port number fields must be configured

to define a port range.

Other values—The first port number field must be configured

and the second must not.

Specify the DSCP priority.

Specify the ToS preference.

Specify the IP precedence.

Select the time range during which the rule takes effect.

Show Quick Links

Table of Contents