Configuring A Rule For An Advanced Ipv4 Acl - HP MSR SERIES Configuration Manual

Hide thumbs Also See for MSR SERIES:

Table of Contents

Check Logging

Source IP Address

Source Wildcard

Configuring a rule for an advanced IPv4 ACL

Select Advanced > QoS Setup > ACL IPv4 from the navigation tree and then select the Advanced Config

tab to enter the rule configuration page for an advanced IPv4 ACL.

Select this box to keep a log of matched IPv4 packets.

A log entry contains the ACL rule number, action on the matched packets, protocol

that IP carries, source/destination address, source/destination port number, and

number of matched packets.

Select the Source IP Address box, and enter a source IPv4 address and source

wildcard, in dotted decimal notation.

Select the time range during which the rule takes effect.

The time ranges available for selection must have been created at the CLI on the

Show Quick Links

Table of Contents