Configuring An Snmp User - HP MSR SERIES Configuration Manual

Figure 260 Creating an SNMP group
2. Configure the SNMP group, as shown in
Table 125 Configuration items
Item
Group Name
Security Level
Read View
Write View
Notify View
ACL

Configuring an SNMP user

Select Advanced > SNMP from the navigation tree, and then click the User tab to enter the page as
shown in Figure
Description
Set the SNMP group name.
Select the security level for the SNMP group. The available security levels are:
•
NoAuth/NoPriv—No authentication no privacy.
•
Auth/NoPriv—Authentication without privacy.
•
Auth/Priv—Authentication and privacy.
IMPORTANT:
The security level for an existing SNMP group cannot be modified.
Select the read view of the SNMP group.
Select the write view of the SNMP group.
If no write view is configured, the NMS cannot perform the write operations to all
MIB objects on the device.
Select the notify view (the view that can send trap messages) of the SNMP group.
If no notify view is configured, the agent does not send traps to the NMS.
Associate a basic ACL with the group to restrict the source IP address of SNMP
packets. To restrict the intercommunication between the NMS and the agent, you
can allow or prohibit SNMP packets with a specific source IP address.
261.
Table 125.
258