Enabling Application Layer Protocol Check; Configuring Connection Limit - HP MSR SERIES Configuration Manual

Item
Host Port

Enabling application layer protocol check

1. From the navigation tree, select NAT Configuration > NAT Configuration.
2. Click the Application Layer Inspection tab.
The application layer protocol check configuration page appears.
Figure 144 Enabling application layer protocol check
3. Configure the parameters as described in
4. Click Apply.
Table 88 Configuration items
Item
Protocol Type

Configuring connection limit

1. From the navigation tree, select NAT Configuration > NAT Configuration.
2. Click the Connection Limit tab.
The connection limit configuration page appears.
Description
Specify internal port number for the internal server.
From the list, you can:
•
Select Other and then enter a port number. If you enter 0, all types of services are
provided. That is, only a static binding between the external IP address and the
internal IP address is created.
•
Select a service and the corresponding port number is provided. You cannot modify
the port number displayed.
Description
Enable/disable checking the specified application layer protocols, including DNS, FTP,
PPTP, NBT, ILS, H.323, and SIP.
Table 88.
145