d.
On the page that appears, enter username user, set the account name user and password
dot1x, select the service dot1x, and click OK.
Figure 86 Adding an account
Verifying the configuration
After you enter username user and password dot1x in the popup dialog box, the client can
•
associate with the device and access the WLAN.
You can view the online clients by selecting Interface Setup > Wireless > Summary from the
•
navigation tree, and then clicking the Client tab.
802.11n configuration example
Network requirements
As shown in
wireless network at a high rate.
Figure 87 Network diagram
IP network
Configuration procedure
1.
Configure a wireless service:
Select Interface Setup > Wireless > Access Service from the navigation tree.
a.
b.
Click Add.
c.
On the page that appears, select the radio unit 1, set the service name to 11nservice, select the
wireless service type clear, and click Apply.
Figure
87, configure the 802.1 1n-capable AP to allow the 802.1 1n client to access the
SSID:11nservice
Router
Client
100