Enabling The Blacklist Function; Adding A Blacklist Entry Manually - HP MSR SERIES Configuration Manual

Step
3.

Adding a blacklist entry manually

4. Viewing blacklist entries

Enabling the blacklist function

From the navigation tree, select Security Setup > Attack Defend > Blacklist to enter the page shown
in Figure 159, where all manually configured or automatically generated blacklist entries are listed.
Select the box before Enable Blacklist and click Apply to enable the blacklist filtering function.
Figure 159 Blacklist page
Adding a blacklist entry manually
On the blacklist page shown in
160.
Remarks
You can add blacklist entries manually, or enable the blacklist function
globally, configure the scanning attack protection function, and
enable the blacklist function for scanning attack protection to allow the
device to add the IP addresses of detected scanning attackers to the
blacklist automatically. For configuration of scanning attack
protection, see "Configuring intrusion
By default, no blacklist entry exists.
IMPORTANT:
Modifying an automatically added entry will change the type of the
entry to Manual.
Optional.
Figure 159, click Add to configure a blacklist entry, as shown in
161
detection."
Figure