Displaying The Active Route Table - HP MSR SERIES Configuration Manual

Figure 184 Static route configuration page
3. Configure static routes as described in
Table 98 Configuration items
Item
Destination IP Address
Mask
Preference
Next Hop
Interface

Displaying the active route table

Select Advanced > Route Setup from the navigation tree to display the Summary tab.
Table 98.
Description
Enter the destination IP address of the static route, in dotted decimal notation.
Enter the mask of the destination IP address.
You can enter a mask length or a mask in dotted decimal notation.
Enter a preference value for the static route. The smaller the number, the higher
the preference.
For example, specifying the same preference for multiple static routes to the
same destination enables load sharing on the routes, while specifying different
preferences enables route backup.
Enter the next hop IP address of the static route, in dotted decimal notation.
Select the outgoing interface of the static route.
If you select Null 0, the destination IP address is unreachable.
179