Ipv4 Static Route Configuration Example; Network Requirements - HP MSR SERIES Configuration Manual

Figure 185 Active route table
Table 99 Field description
Field
Destination IP Address
Mask
Protocol
Preference
Next Hop
Interface

IPv4 static route configuration example

Network requirements

The routers' interfaces and the hosts' IP addresses and masks are shown in
configure static routes on the routers for any two hosts to communicate with each other.
Description
Destination IP address of the route.
Mask of the destination IP address.
Routing protocol that discovered the route, including static route, direct
route, and various dynamic routing protocols.
Preference for the route.
Next hop address of the route.
Output interface of the route. Packets destined for the destination IP address
are forwarded out of the interface.
180
Figure 186. You must