Configuring 802.11N Mcs; Displaying Radio; Displaying Wlan Services Bound To A Radio - HP MSR SERIES Configuration Manual

Configuring 802.11n MCS

Configuration of mandatory and supported 802.1 1n rates is achieved by specifying the maximum
Modulation and Coding Scheme (MCS) index.
Select Interface Setup > Wireless > Radio from the navigation tree, and click the Rate tab
Figure 105 Setting 802.11n rate
Table 62 Configuration items
Item
Mandatory Maximum MCS
Multicast MCS
Supported Maximum MCS
For more information about MCS, see WLAN Configuration Guide in HP MSR Router Series
Configuration Guides (V5).
Make the MCS configuration the same on all APs in mesh configuration.

Displaying radio

Displaying WLAN services bound to a radio

Select Interface Setup > Wireless > Summary from the navigation tree, click the Radio tab, click the
specified radio unit, and select the Wireless Service tab to view the WLAN services bound to the radio.
Description
Set the maximum MCS index for 802.11n mandatory rates.
IMPORTANT:
If you select the client dot11n-only option, you must configure the mandatory
maximum MCS.
Set the multicast MCS for 802.11n.
The multicast MCS is adopted only when all the clients use 802.11n. If a non
802.11n client exists, multicast traffic is transmitted at a mandatory MCS data
rate.
IMPORTANT:
When the multicast MCS takes effect, the corresponding data rates defined for
20 MHz are adopted no matter whether the 802.11n radio operates in 40 MHz
mode or in 20 MHz mode.
Set the maximum MCS index for 802.11n supported rates.
112