Setting The Background Image For The Winet Topology Diagram - HP MSR SERIES Configuration Manual

1. Select WiNet from the navigation tree.
When WiNet is disabled, a dialog box Only the WiNet administrator supports the function
appears.
2. Click OK to enter the Setup page, as shown in
3. Configure WiNet, as shown in
Figure 532 WiNet setup page
Table 205 Configuration items
Item
WiNet Name
Management VLAN
IP Pool (Administrator IP)
Mask of IP Pool
After a WiNet is built, you cannot configure items on the Setup page, and the Build WiNet button
changes to Close WiNet. To delete the WiNet, click the Close WiNet button.

Setting the background image for the WiNet topology diagram

The WiNet topology diagram is displayed in the WiNet Management page and uses a white
background by default. You can customize the background image by uploading a JPG or BMP image
(which is less than 0.5 MB).
Select WiNet from the navigation tree and then click the Setup tab to enter the configuration page as
shown in Figure
Table
Description
Enter a WiNet name.
Enter a management VLAN ID in the WiNet. You can enter an existing static
VLAN only.
The management VLAN is used by WiNet packets for communication. It
actually defines the WiNet management range and delivers the following
functions:
•
Isolates WiNet management packets from other packets.
•
Enables internal communication between the administrator, members, and
candidates.
WiNet management requires that the management VLAN traffic be permitted
on the administrator's ports (including cascade ports if there is any) connected
to members, candidates, and the external network.
Enter an IP address and select a network mask for the administrator. After that,
each WiNet member is assigned an IP address on the same subnet as the
administrator.
532.
Figure 532.
205.
508