HP MSR SERIES Configuration Manual page 183

Enter IP address 5.5.5.5, the IP address of Host D.
•
• Select Permanence for this blacklist entry.
Click Apply.
•
Click Add and then perform the following configurations, as shown in
•
Figure 167 Adding a blacklist entry for Host C
Enter IP address 192.168.1.5, the IP address of Host C.
•
Select Hold Time and set the hold time of this blacklist entry to 50 minutes.
•
Click Apply.
•
# Configure intrusion detection: Enable scanning attack protection, and enable blacklist function for it;
enable Land attack protection and Smurf attack protection.
Select Security Setup > Attack Defend > Intrusion Detection from the navigation tree and then
•
perform the following configurations, as shown in
Figure 168 Configuring intrusion detection
Figure 168.
166
Figure 167: